If you haven't already done so, you must remove the system
processor assembly before you install the IBM® Power® 750 (8408-E8D) and IBM PowerLinux™ 7R4 (8248-L4T).
CAUTION:
The system processor assembly requires
two people to remove from the system.
Attention: The
system processor assembly weighs 45 lbs. Use caution when you are
sliding the system processor assembly out of the enclosure.
- Prepare to remove the system processor assembly:
- Using a slotted screwdriver, loosen both the captive screws (A),
if present.
- Rotate the handles (B) in the direction that is shown until
they stop.
- Hold and pull both the handles and begin sliding the system processor
assembly out of the enclosure until the slide release buttons on each
side of the processor assembly lock into place.
Figure 1. Preparing to remove the system processor assembly
- Remove the system processor assembly.
- Slide the card release tabs (C) toward the rear of the
system.
- With two people, one on each side of the assembly, lift
the system processor assembly off of the rails by using both handles
on each side. Then move the assembly horizontally away from the rack
to clear the rails.
Figure 2. Removing system processor
assembly
- Place the system processor assembly on an ESD surface.
- Push in the system processor assembly rails:
- Lift the slide release buttons (one on each side) to unlock the
rails (D).
- Push both the rails (E) back into the enclosure.
Figure 3. Push in the system processor assembly rails