POWER7 information

7042-CR6 rack-mounted Systems Director Management Console specifications

Hardware specifications provide detailed information for your IBM® Systems Director Management Console (SDMC), including dimensions, electrical, environmental requirements, and noise emissions.

The SDMC controls managed systems, including the management of logical partitions and the use of capacity on demand. Using service applications, the SDMC communicates with managed systems to detect, consolidate, and send information to IBM for analysis. The SDMC provides service technicians with diagnostic information for systems that can operate in a multiple-partitioned environment.

Use the following specifications to plan for your SDMC.

Table 1. Dimensions
Width Depth Height Weight (maximum configuration)
440 mm (17.3 in.) 711 mm (28.0) 43 mm (1.7 in.) 15.9 kg (35.1 lb)
Table 2. Electrical requirements
Electrical characteristics Properties
Maximum measured power 675 W
Maximum kVA 0.7 kVA
Minimum thermal output 662 BTU/hr
Maximum thermal output 2302 BTU/hr
Input voltage low range 100 V ac - 127 V ac
Input voltage high range 200 V ac - 240 V ac
Frequency (Hertz) 47 Hz - 63 Hz
Table 3. Environmental requirements
Environment Temperature
Recommended operating temperature 10°C - 35°C (50°F - 95°F)
Nonoperating temperature 5°C - 45°C (41°F - 113°F)
Maximum altitude 3048 m (10000 ft)
Operating humidity 8% - 80%
Nonoperating humidity 20% - 80%
Table 4. Noise emissions (maximum configuration)1
  Idling Operating
LWAd 6.1 bels 6.1 bels
1 These levels were measured in controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a specific location might exceed the average values stated because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will operate.


Send feedback Rate this page

Last updated: Thu, March 15, 2018