Use this procedure to resolve the following problem: Missing
remote adapter (SRC xxxx9076)
An adapter attached in a dual storage IOA configuration
was not discovered in the allotted time. Determine which one of the
following items is the cause of your specific error and take the appropriate
actions listed. If this action does not correct the error, contact
your hardware service provider. The possible causes are:
- An attached adapter for the configuration is not installed or
is not powered on. Some adapters are required to be part of a Dual
Storage IOA Configuration. Ensure that both adapters are properly
installed and powered on.
- If this configuration is a dual storage IOA configuration, then
both adapters might not be in the same partition. Ensure that both
adapters are assigned to the same partition.
- An attached adapter does not support the desired configuration.
See SAS RAID configurations to
determine the allowable configurations. Then correct the configuration.
If correcting the configuration does not resolve the error, contact
your hardware service provider.
- An attached adapter for the configuration failed. Take action
on the other errors that have occurred at the same time as this error.
- Adapter code levels are not up to date or are not at the same
level of supported function. Ensure that the code for both adapters
is at the latest level.
Note: The adapter that is logging this error will run in a performance
degraded mode, without caching, until the problem is resolved.
This
ends the procedure.
Subscribe to this information