This function allows you to perform a system power control
network (SPCN) operation.
This function is available only in the manual operating
mode and from power on standby.
Notes: - The system that will display the ID must be powered off with ac
power applied.
- If you have just restored power to the system, the service processor
must return to standby mode before the control panel functions will
work correctly. Returning the service processor to standby mode takes
a few minutes after the panel appears to be operational.
- The control panel must be in manual operating mode to access function
07 options.
To perform an SPCN operation that is controlled by
function 07, do the following:
- Select function 07, and then press Enter. 07** is
displayed.
- Select the function that you want to perform
(see Table 1). Use the Increment
or Decrement buttons (↑↓) to scroll to the appropriate function. Press
Enter to display 07nn00, where nn is
the function that you selected.
Table 1. SPCN functions
in function 07| Function |
Description |
For more information |
|---|
| A1 |
Broadcasts a power-on command. |
Go to step 5. |
| A6 |
Displays frame address on all I/O enclosures. |
Go to step 5. |
| A8 |
Displays the SPCN configuration ID number for
a selected frame. |
07A8 is displayed. Go to step 3. |
| A9 |
Sets the SPCN configuration ID for a selected
frame. |
07A9 is displayed. Go to step 4. |
- If you selected function A8 in step 2, complete the
following steps to display the configuration of the I/O enclosure:
- Use the Increment (↑) or Decrement (↓) buttons to select the first
two characters of the frame address of the I/O enclosure, and then
press Enter. 07nn00 is displayed,
where nn is the first byte of
the frame address.
- Use the Increment (↑) or Decrement (↓) buttons to select the second
two characters of the frame address of the I/O enclosure, and then
press Enter. 07nn00 is displayed
on the selected I/O enclosure, where nn is
the second byte of the frame address.
Notes: - The display on the addressed I/O enclosure is blinking on and
off.
- The configuration ID is the last two characters of the bottom
line.
- If you selected function A9 in step 2, complete the
following steps to set the configuration of the selected I/O enclosure:
- Ensure that the system power of the selected I/O enclosure is
in standby mode. If the system power of the selected I/O enclosure
is not in standby mode, power it off. Then return to step 1.
- Use the (↑) or Decrement (↓) buttons to select the first two characters
of the frame address of the I/O enclosure to configure, and then press
Enter. 07nn00 is displayed, where nn is
the first byte of the unit address.
- Use the Increment (↑) or Decrement (↓) buttons to select the second
two characters of the frame address of the I/O enclosure, and then
press Enter. 07nn00 is displayed, where nn is
the second byte of the frame address.
Note: The display on the addressed
I/O enclosure is blinking on and off.
- Use the Increment (↑) or Decrement (↓) buttons to select the correct
configuration ID. 07nn is displayed, where nn is
the configuration ID.
- Press Enter. 07nn00 is displayed. After
20 to 30 seconds, the display on the addressed I/O enclosure stops
blinking and returns to the normal display format.
- Scroll to 07** using the
Increment (↑) or Decrement (↓) buttons, and then press Enter. This
returns the control panel to the normal display.
Subscribe to this information