Learn how to install a disk drive bezel into a disk drive.
You must have removed the disk drive bezel from either
a failed disk drive that had a bezel installed in it or from the disk
drive filler. To remove a disk drive filler, see
Removing a disk drive bezel from a disk drive or filler. Perform the steps in this
procedure only if the disk drive or the disk drive filler removed
had a disk drive bezel attached to it.
Note: If the disk drive bezel
does not have a thumbscrew, it is not removable and is a SAS disk
drive. The replacement SAS disk drive comes with an attached bezel.
- Attach the disk drive bezel (A) to
the disk drive or to a disk drive filler.
Attention: - Attach a wrist strap to an unpainted metal surface of your hardware
to prevent electrostatic discharge (ESD) from damaging your hardware.
- When using a wrist strap, follow all electrical safety procedures.
A wrist strap is for static control. It does not increase or decrease
your risk of receiving electric shock when using or working on electrical
equipment.
- If you do not have a wrist strap, just prior to removing the product
from ESD packaging and installing or replacing hardware, touch an
unpainted metal surface of the system for a minimum of 5 seconds.
- Press in and then tighten the thumbscrew (B) to
secure the bezel to the disk drive or filler.
- Install the disk drive bezel latch (C) onto the
front of the disk drive or filler, as shown in Figure 1.
Figure 1. Attaching a bezel to a disk drive filler
Return to the procedure that brought you here.
Subscribe to this information
