If you are using a new integrated server with an Integrated
Management Module (IMM) service processor, you might need to configure
networking settings before you can sign into it with the Web interface.
Do the following steps to configure the IMM.
- Turn on the System
x product.
Refer to the system documentation to complete this step.
- When the IBM System
x Server Firmware image appears on the display, press F1 to
go to setup.
- Highlight System Settings using
the up or down arrow keys and press Enter to
select.
- Highlight Integrated Management Module using
the up or down arrow keys and press Enter to
select.
- Highlight Network Configuration using
the up or down arrow keys and press Enter to
select.
- Highlight Network Interface Port using
the up or down arrow keys and select Dedicated.
- Highlight the Hostname using the
up or down arrow keys and select Hostname.
Enter the value from work sheet item XSP2.
- Highlight DHCP Control using the
up or down arrow keys and select Static IP.
- Highlight Static IP Address using
the up or down arrow keys, press Enter. Type
in the IP address from work sheet item XSP4.
- Highlight Subnet Mask using the
up or down arrow keys, press Enter. Type in
the subnet mask from work sheet item XSP5.
- Highlight Gateway using the up or
down arrow keys, press Enter. Type in the gateway
address from work sheet item XSP6.
- Highlight Save Network Settings using
the up or down arrow keys and press Enter
to select and perform the action. A screen displays confirming the
action.
- Press Esc until the Main
Menu is shown. Then select Save Settings and
then Exit Setup.