The DVD-RAM type II disc can be removed from its cartridge
and played in a DVD-ROM or DVD-RAM drive that is compatible with the
DVD-RAM type II disc.
Attention: Be careful when handling removed
discs. Debris, dust particles, fingerprints, smears, or scratches
can affect recording and playback of discs. Do not use solvents to
clean disc surfaces. To clean a disc, use a soft, lint free cloth
and gently wipe the disc surface outwards from the center hole to
the outer edge. Do not rub, make circular motions or try to follow
the circular lines in the disc. When labeling a disc, write only on
the printed label side, using a soft felt-tip marker. Do not use a
hard-tip pen to write on disc surface. Keep out of direct sunlight,
high temperatures, and humidity. Do not attach labels to either side
of the disc.
Removing a disc from the cartridge
To remove
a disc from the cartridge, do the following steps:
Note: Handle the
disc only by its edges.
- Use the tip of a ballpoint pen to push the locking pin up and
out of the disc cartridge.
- Use the tip of a ballpoint pen to push down on the lock button
while pulling the cartridge lid open.
- With the cartridge lid open, slide the disc out of the cartridge.
Table 1. Index number and corresponding description
for removing a disc from the cartridge| Index number |
Description |
|---|
| 1 |
Locking Pin |
| 2 |
Lock Button |
| 3 |
Cartridge Lid |
Returning a disc to the cartridge
To return
a disc to the cartridge, do the following steps:
Notes: Both the disc label and the cartridge label should be
facing up. Handle the disc only by its edges.
- Slide the disc into the cartridge.
- Close the cartridge lid. Make sure the lock button snaps into
position.
- Install the locking pin.
Subscribe to this information
