Placing the 8233-E8B or 8236-E8C in
the operating position
Use this procedure to place the system or expansion unit
in the operating position to make the unit available for use.
To place the system into the operating position follow
these steps:
Tip: Some of the figures in these procedures
might not look exactly like the system or expansion unit that you
have. However, the steps to perform the task are the same.
Simultaneously release the blue rail safety latches (B),
located near the front of each rail, and push the system or expansion
unit into the rack as shown in the following figure.
Note: Ensure
that the cables at the rear of the system or expansion unit do not
catch or bind as you push the unit back into the rack.
Figure 1. Releasing the rail safety latches
Replace and tighten the two thumbscrews (C) that
secure the system or expansion unit (A) to
the rack as shown in the following figure.
Subscribe to this information
