Power on

Edit online

Preparing the compact KMM (keyboard, monitor, mouse)

Complete the following procedure to assemble the compact KMM (keyboard, monitor, mouse) support hardware:

  1. Retrieve the compact KMM from the KMM storage box.
    KMM storage box location, top of frame
  2. Unscrew the KMM frame bracket (P/N 02WN899) and the KMM mounting bracket (P/N 02WN992) from the KMM support arm (P/N 02WN481).
    KMM support arm assembly
  3. Install the KMM frame bracket on the inner left or right side of the frame. Use the attached screw to fasten the bracket in one of the three existing holes at EIA 24 on the inner frame.
    KMM frame bracket
  4. Fasten the KMM mounting bracket to the KMM support arm using the 2 attached screws.
  5. Fasten the KMM support arm to the KMM frame bracket using the 2 attached screws.
    KMM frame bracket
  6. Place the compact KMM onto the mounting bracket and pull the KMM towards you to fasten.
    KMM frame bracket
  7. Open the compact KMM and tilt the monitor to a usable position.
    KMM frame bracket
  8. Retrieve the white USB-C cable (P/N 02EC951) from the KMM storage box; 2 cables are provided (1 spare).
  9. If fastening the KMM to the front of the frame, plug the white USB-C cable into the primary interface adapter as shown below. Then go to Step 11.
    KMM frame bracket
  10. If fastening the KMM to the rear of the frame:
    1. Remove the blue protective cap from the USB-C connector.
      blue protective cap from the USB-C connector
    2. Plug the white USB-C cable into the connector.
      KMM frame bracket
  11. Plug the other end of the white USB-C cable into the port on the compact KMM.
    KMM frame bracket

Power on

  1. The green PSU PWR LED on the PSUs will turn on solid.
  2. Wait for the Primary Support Element Logon window to appear.
    1. If the Alternate Support Element window appears, click the non-lit selection button on the front end of the interface adapter to return to the Primary Support Element.
      Note: The Support Element selection buttons light up when the related Support Element is selected. This allows you to know which Support Element is communicating with the compact KMM at any given time.
      KMM frame bracket
    2. If the Hardware Management Appliance feature (FC 0100) is installed, the Hardware Management Appliance HMC Logon window will appear.
      1. Logon to Hardware Management Appliance HMC.
      2. From the Tasks Index, click Virtual Support Element Management Task.
      3. From this task, click Start SE Virtual Machine to start the Virtual Support Element.
      4. Click Show SE Console. Wait for the Primary Support Element Logon window to appear.
      5. If the Alternate Support Element window appears, click the top button on the KVM switch to the other Hardware Management Appliance HMC. Then repeat Step 2b to start the Primary Support Element.
  3. On the Primary Support Element Logon window:
    • Type SERVICE in the Username field.
    • Type SERVMODE in the Password field.
  4. Click System Management.
  5. Select the system name.
  6. Click Service.
  7. Click Service Status.
  8. If Service Status is already enabled, skip to Step 9. Otherwise, complete the following steps:
    1. If required, select the check box.
    2. Click Options.
    3. Click Enable service status.
    4. Click Save.
    5. Click Yes.
    6. Click OK, if applicable.
    7. Click Cancel to close.
  9. Click Recovery.
  10. Click Power-On.
  11. Click OK to close the window when system power-on completes successfully.