Stand-alone installation

About this task

Complete the following steps to install the device as a stand-alone unit on a table.

Procedure

  1. Unpack the device and verify that the items listed under Shipping carton contents are present and undamaged.
  2. Apply the adhesive rubber feet to the underside of the device. The rubber feet help prevent the device from sliding off the supporting surface.
    1. Clean the indentations at each corner of the bottom of the device to ensure that they are free of dust or other debris that might lessen the adhesion of the feet.
    2. With the adhesive side against the chassis, place one rubber foot in each indentation and press into place.
  3. Place the device on a sturdy flat surface.
  4. Provide power to the device as described in Providing power to the device.
    Note: Do not connect the device to the network until the IP address is set correctly. For instructions on how to set the IP address, see Configuring the IP address.