Installing an AC power supply

Use this procedure to install an AC power supply.

About this task

CAUTION:
Use both hands to install and remove power supplies. Each AC power supply weighs up to 6 lb (2.7 kg).

Procedure

To install an AC power supply in the IBM c-type SAN Device, complete the following steps.

  1. Ensure that the system (earth) ground connection has been made. See the System Grounding.
  2. If a filler panel is installed, remove the filler panel from the power supply bay by loosening the captive screw.
  3. Ensure that the power switch is in the off (0) position on the power supply you are installing.
  4. Grasp the power supply handle with one hand, place your other hand underneath the power supply, and slide the power supply into the power supply bay. Ensure that the power supply is fully seated in the bay.
  5. Plug the power cable into the power supply, and place the cable retention device to ensure that the cable cannot be pulled out.
  6. Connect the other end of the power cable to an AC power source.
  7. Turn the power switch to the on (|) position on the power supply. Turning the power switch on also locks the power supply in the bay.
  8. Verify power supply operation by checking that the power supply LEDs are in the following states:
    • Input OK LED is IN.
    • Output Fail LED is Fault.
    • ID LED is blue.