HP SNAplus2 Configuration Requirements

For HP SNA support, you must install and configure HP SNAplus2API, SNAplus2-Common, and SNAplus2-Link software. Perform the following steps to configure your system:

  1. Use a text editor or xsnapadmin to create a configuration file named /etc/opt/sna/sna_node.cfg.
  2. Add the following entry to the /etc/opt/sna/sna_tps file: 
    ["NNV2DTF"]
TYPE=QUEUED-BROADCAST
USERID=XXXXX
  3. To start the SNA 3.0 support, log in as root and type the following command:
    snap start
  4. To validate or modify your configuration, start the local node, log in as root, and type the following command:
    snapadmin

    For additional information about configuring for SNAplus2 10.10 connectivity, refer to the Hewlett-Packard documentation.

    The following example displays the contents of a file that contains the required IBM® Connect:Direct® AT&T Servers SNA 3.0 Invokable TP definition. This file, sna_tps, is provided in the directory d_dir/etc.

    ["NNV2DTF"]

    TYPE=QUEUED-BROADCAST