00E4070D
Explanation
An error was detected while attempting to update the EPOCH column of SYSIBM.SYSTABLEPART table.
System action
Utilities processing is abended. The abend might be accompanied by message DSNT500I. An SDUMP might be taken.
User response
Correct the 'resource unavailable' condition identified by the DSNT500I message. Either restart the utility from the last commit point or terminate the utility and start it again from the beginning. For an explanation of the resource-type value, see Resource types.
If DSNT500I was not issued, register 2 contains a secondary Db2 reason code that gives more information about the problem. If the secondary reason code is not documented in this manual, it is an internal IBM® code.
Problem determination
If the condition cannot be corrected, determine the failing environment. If you suspect an error in Db2, you might need to report the problem. For information about identifying and reporting the problem, see Collecting diagnostic data.
- Console output from the system on which the job was run, and a listing of the SYSLOG data set for the period of time that spans the failure.
- A listing of the SYS1.LOGREC data set, obtained by executing IFCEREP1.
- SYSPRINT output, including JCL, for the application program or batch job, and system messages that were issued. Make sure that MSGLEVEL=(1,1) on the JOB statement so that all diagnostic information is sent to SYSPRINT.
- UTPRINT output, produced by utility invocation of SORT.
- Dynamic dump, taken to SYS1.DUMPxx data set, by Db2 (for 04E and 04F abends). Availability of this dump is dependent on the failing environment.
- SYSABEND, SYSUDUMP, or SYSMDUMP output. Availability of these dumps is dependent on the failing environment.