Complete this task to replace a hot-swap power
supply in 3958 DD4 and DD5 servers.
Procedure
Perform the following steps
to install a hot-swap power
supply:
- Touch the static-protective package
that contains the power
supply to any unpainted surface on the outside of the server; then,
remove it from the package.
- Slide the orange
release latch on the handle 2 to
the right and lift the handle 3 up to
the open position if it is not already in the open position (see Figure 1).
- Push the power supply 1 into
the bay, slide the latch to the right, and push the handle down to
lock it.
Figure 1. Replacing the power supply
- Connect
one end of the power cord for the new power supply
into the ac inlet on the back of the power supply, and connect the
other end of the power cord into a properly grounded electrical outlet.
- Route the cable through the retention hook on the
back
of the power supply.
- If the server is turned
off, turn on the server.
- Ensure that the ac
and dc power LED on the power supply
is lit, indicating that the power supply is operating correctly.
