modifyWMQTopic command

Use the modifyWMQTopic command to change certain parameters of a IBM MQ messaging provider topic.

To run the command, use the AdminTask object of the wsadmin scripting client.

[IBM i]The wsadmin scripting client is run from Qshell. For more information, see the topic about configuring Qshell to run product scripts.

This command is valid only when it is used with WebSphere® Application Server Version 7 and later application servers. Do not use it with earlier versions.

For a list of the available IBM® MQ messaging provider administrative commands, plus a brief description of each command, enter the following command at the wsadmin prompt:

print AdminTask.help('WMQAdminCommands')

For overview help on a given command, enter the following command at the wsadmin prompt:

print AdminTask.help('command_name')

After using the command, save your changes to the master configuration. For example, use the following command:

AdminConfig.save()

Purpose

Use the modifyWMQTopic command to modify a IBM MQ messaging provider topic defined at the scope at which the command is issued.

Note: You cannot change the name of an topic.

Target object

A IBM MQ messaging provider topic at the specific scope.

Required parameters

The parameters for this command are identical to those used to create a IBM MQ messaging provider topic.

Optional parameters

The parameters for this command are identical to those used to create a IBM MQ messaging provider topic.

Note the behavior of this command on the -customProperties parameter.

-customProperties
This parameter specifies custom properties to be passed to the IBM MQ messaging provider topic implementation. Typically, custom properties are used to set attributes of the topic that are not directly supported through the WebSphere administration interfaces.
Each custom property is specified using name and value table step parameters. Since these are table steps, the order of the two parameters is fixed, so you must always specify the name first and the value second:
  • In Jython: [name value]
  • In Jacl: {name value}
New name/value pairs are added to the existing set of custom properties using the following rules:
  • If the existing set of properties does not contain a property with the same name as that supplied as part of a modify command, the supplied property is added to the set of custom properties, unless the custom property has no value specified, when it is disregarded.
  • If the existing set of properties contains a property with the same name as that supplied as part of a modify command, and the modify command also specifies a value for the property, the existing value is replaced by the supplied value.
  • If the existing set of properties contains a property with the same name as that supplied as part of a modify command, but the modify command does not specify a value for the property, the property with the same name is deleted from the existing set of custom properties.

Example

  • Using Jython:
    wsadmin>AdminTask.modifyWMQTopic("t1(cells/L3A3316Node04Cell/
nodes/L3A3316Node05|resources.xml#MQTopic_1204538835312)", ["-priority 7"]) 
t1(cells/L3A3316Node04Cell/nodes/L3A3316Node05|resources.xml#
MQTopic_1204538835312)
  • Using Jacl:
    wsadmin>$AdminTask modifyWMQTopic 
t1(cells/L3A3316Node04Cell/nodes/L3A3316Node05|resources.xml#
MQTopic_1204538835312) {-priority 7} 
t1(cells/L3A3316Node04Cell/nodes/L3A3316Node05|resources.xml#
MQTopic_1204538835312)