Performing an LED test on the control panel

You can perform an LED test on the control panel to determine whether one of the LEDs is not functioning properly.

About this task

To perform this operation, you must have one of the following authority levels:
  • Administrator
  • Authorized service provider

To perform an LED test on the control panel, complete the following steps:

Procedure

  1. In the ASMI Welcome pane, specify your user ID and password, and click Log In.
  2. In the navigation area, expand System Configuration and Service Indicators.
  3. Select Lamp Test.
  4. In the Lamp Test pane, click Continue to perform the lamp test. When a lamp test is started, the firmware-controlled indicators in the central electronics complex (CEC) and on the expansion units are turned on solid for 4 minutes, and then restored to their previous states.