Removing an adapter from the 9009-41A, 9009-41G, 9009-42A, 9009-42G, 9223-42H, or 9223-42S system

To remove an adapter from the system, complete the steps in this procedure.

Procedure

  1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged into a ground jack or connected to an unpainted metal surface. If not, do so now.
  2. To remove an adapter, complete the following steps:
    1. Set the adapter latch (A) in the target slot to the open position by rotating the latch (A) in the direction that is shown in the following figure.
      (L007)
      CAUTION:
      A hot surface nearby. (L007)
    2. Carefully grasp the adapter (B) by its top edge or tailstock, and remove the adapter from the slot as shown in the following figure.
      Attention: A pin on the tailstock of the adapter resembles a removable screw. Do not remove this pin. It is required for correct alignment and seating.
      Figure 1. Removing an adapter from a 9009-41A, 9009-41G, 9009-42A, 9009-42G, 9223-42H, or 9223-42S rack-mounted system
      Removing an adapter from a rack-mounted system
      Figure 2. Removing an adapter from the 9009-41A stand-alone system
      Removing an adapter from the 9009-41A stand-alone system
  3. Place the removed adapter on an approved ESD surface.