Installing a Slimline media device in the 9080-MHE, 9080-MME, 9119-MHE, or 9119-MME system with the power turned on in an IBM i system

To install a Slimline media device in the 9080-MHE, 9080-MME, 9119-MHE, or 9119-MME system with the IBM® i system or IBM i logical partition power turned on, complete the stesp in this procedure.

1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Remove the filler and service procedure manual, if present.
   1. Grasp the filler and slide it out of the system.
   2. Remove the service procedure manual from the slot above the filler.
3. Find the package that contains the new media device and remove it from the static-protective package.
4. Complete the following steps in the IBM i system:
   1. If you have not done so already, sign on with Service Tools Authority.
   2. On an IBM i command line, type strsst, and then press Enter.
   3. Type your service tools user ID and service tools password on the System Service Tools (SST) Sign On display. Press Enter.
   4. Select Start a service tool from the SST menu and press Enter.
   5. Select Hardware service manager from the Start a Service Tool menu and press Enter.
   6. Select Device Concurrent Maintenance from the Hardware Service Manager display and press Enter. The following figure is an example of the display.
      Figure 1. Example display of device concurrent maintenance

      
   7. If the physical location does not appear in the Device Concurrent Maintenance display, complete the following steps:
      1. Find the feature code (FC) and sequence number (SN or SEQ) on the label that appears on the front of the system unit as shown in the following figure.
      2. In the Specify either physical location or resource name field, type the physical location where you want to replace the media device. In the previous example, opt04 is the device resource name.
      Figure 2. Example of the label on the front of the system unit

      
   8. Select option 2 (Install device) for the action to be performed.
   9. Set the time delay by using the console. In the Enter a time value between 00 and 19 field type 01, if you want to set the time delay for one minute.
   10. Press Enter. Observe the lights on the left side of the media devices. When you press Enter, after a 1-minute delay (or the time you set), the amber light comes on solid.
       Important: You have 15 seconds to insert the media device.
5. Install the Slimline media device by completing the following steps:
   1. Ensure that the Slimline media device handle (A) is rotated open as shown in Figure 3.
   2. Using your hand to support the bottom of the Slimline media device, align the device with the media bay.
   3. Slide the device into the system and rotate the handle (A) in the direction shown until the latch locks in place.
   Figure 3. Installing a Slimline media device in an 9080-MHE, 9080-MME, 9119-MHE, or 9119-MME system control unit

   
6. Connect one end of the USB cable to the USB port at slot P1-C11-T1 on the rear of the system control unit and the other end to the USB port on the PCIe USB adapter (FC EC45 or EC46) in the system node.
   Figure 4. Connect the USB cable to the 9080-MHE, 9080-MME, 9119-MHE, or 9119-MME system control unit rear USB port at slot P1-C11-T1